Free tool · HUD stats

VPIP & PFR Poker Stats: Player Types Calculator

VPIP and PFR are the two numbers every HUD shows first. Enter them, plus the number of hands, and get the player type, how much to trust the read, and how to adjust against it. Use it on your own stats too.

VPIP / PFR player type calculator

Get AF from postflop counts

Types use rule-of-thumb cut-offs for 6-max cash games; full ring runs about 5 points tighter. A stat is only as good as its sample, so the calculator shows a 95% range.

VPIP and PFR player types (6-max)

VPIP / PFRTypeHow to adjust
45 / 32ManiacWider value bets, call down lighter, 3-bet for value more. Do not bluff into a player who never folds.
42 / 10Loose-passive (calling station)Value bet thinly and size up; cut bluffs. A raise from this player usually means a strong hand.
28 / 22LAG (loose-aggressive)3-bet and 4-bet wider for value, trap more, and expect bluffs on scary cards.
22 / 18TAG (tight-aggressive)A solid regular. Steal their blinds less, respect their 3-bets, look for spots where they over-fold.
12 / 9NitSteal their blinds relentlessly; fold to their 3-bets with anything but strong hands.
18 / 7Tight-passive (rock)Bet for value when they check; when they raise, believe it. Bluff them on the flop, not the river.

Read the gap before the size. PFR close to VPIP means the player raises what they play: aggressive. A wide gap means they call a lot preflop, and callers are easier to beat. The aggression factor adds the postflop half: below about 1.5, even a player who raises preflop tends to give up after the flop.

How many hands until the stats mean something?

A HUD number is a sample, not a fact. 95% range of the true stat when the HUD shows VPIP 25% / PFR 20% (Wilson interval):

HandsTrue VPIP somewhere inTrue PFR somewhere in
5016%–40%11%–33%
20020%–31%15%–26%
1,00022%–28%18%–23%
5,00024%–26%19%–21%

After 50 hands, “25/20” is consistent with a true VPIP anywhere from 16% to 40%: a tight regular or a loose one. After 1,000 it is a real read. Rule of thumb: ±5 points needs about 289 hands; ±2 points needs about 1,801. Positional stats and 3-bet need many more, because each hand gives only one chance to 3-bet when someone has already opened.

Your own VPIP and PFR

FAQ

What do VPIP and PFR mean in poker?

VPIP (voluntarily put money in pot) is the share of hands where a player calls or raises preflop, not counting posting the blinds. PFR (preflop raise) is the share of hands where they raise preflop. PFR can never be higher than VPIP, because every raise also counts as putting money in.

What is a good VPIP and PFR?

There is no single right number, but solid 6-max cash regulars are often around 20–27% VPIP with PFR only a few points lower. Full ring runs about 5 points tighter. A big gap between VPIP and PFR means the player calls too often, which is usually the bigger leak than the raw VPIP.

How many hands do I need for VPIP and PFR to be reliable?

For a stat near 25%, about 289 hands get you within ±5 points (95% confidence) and about 1,801 get you within ±2 points. Rarer stats like 3-bet need far more chances: a 7% 3-bet takes about 626 opportunities for ±2 points.

What is aggression factor in poker?

Aggression factor (AF) is postflop (bets + raises) ÷ calls. A value below about 1.5 is passive; 2–3 is typical for solid regulars; above 4 is very aggressive. Aggression frequency (AFq) divides bets + raises by bets, raises, calls and folds, so it reads as a percentage.

What VPIP and PFR does a LAG have?

A loose-aggressive player typically plays 25% or more of hands and raises most of them, so PFR stays close to VPIP. The ratio matters: 28/22 is a LAG, 28/10 is a loose caller.

Related free tools

Unleash the Madman by Jack Maniac, book cover

Know the type. Then attack it.

Unleash the Madman by Jack Maniac is a short No-Limit Hold’em playbook for aggressive players: how to pressure nits, value-bet stations and stay ahead of the regulars. $9.99 on Kindle, or read it on Kindle+.

Get Unleash the Madman: $9.99 on Kindleor read it on Kindle+Read a free sample